If you choose to use something else, please make a note of it so your can remember it.
NCF recommends using your DSL password as administrative password for your modem. Enter the Current Password admin, the new password and confirm the new password and select Save Click Change under the Password section of the Administrator Settings 11. Return to the Home page and click on the Modem Settings link at the bottom of the page and enter the default password "admin" when prompted. However, we understand this involves additional post-configuration work that not all members are interested in or equipped for.Īt this point, the modem will be ready for test on ADSL/VDSL (whatever connection you have) and also over wifi.Ĭhange the Administrative Password 9. If you set diffferent network names you will be able to determine which works better on specific clients. Keeping the same network name (SSID) for 2.4GHz and 5GHz wifi connections is okay so far as you understand the pros and cons. Set the WiFi SSID and the WiFi password in the 2.4Ghz network. Select the Primary tab on the left of the page. If prompted for the admin password enter admin like before. After getting a successful internet authentication, go back to the home page and click on the WiFi settings button below the listed WiFi networks in the Manage my Wi-Fi section. Your DSL/PPPoE username is in the format and your DSL/PPPoE password can be obtained from if you cannot locate it.Ĭhanging WiFi Settings 7. It could take up to 30 seconds for the Status to change to Connected. Enter your NCF DSL /PPPoE username and password into the Username and Password fields and click Save. Click on the Settings button and enter the default password admin when prompted.Ħ. The Status will say disconnected if there's currently no working internet/PPPoE configuration settings on the modem.ĥ. At the Top Left of the Landing page, click on Fibe Internet. Choose "No" because the Bell password recovery would only work for a Bell DSL customer. After any successful login, the modem configuration server may ask if you want to use password recovery. Enter into the address bar of your browserĬhanging Internet/PPPoE Login Settings 3. Wi-Fi is enabled with a default configuration that must be changedĢ. The modem is not configured to authenticate for an NCF Internet connection. The firewall is enabled and properly configured. Gateway and configuration server are 192.168.2.1. Configuration server password is "admin". Configuration server username is "Administrator". Wait for the Power light to flash 5 times and release the reset button. Perform a factory reset by holding the reset button on the side of the modem down for 30 seconds. Connect the modem to DSL connection and via Ehternet to the computer. It's best to congifure this modem from factory settings but that means that you existing internet connection will be lost(if your moving from another DSL provider to NCF). 2 Changing Internet/PPPoE Login Settings.
0 kommentar(er)
